Notes:

When installing these studs into a plate or board, try to keep the hole size consistant. If the hole is too large the parts will not install properly and can even be removed with out much force resulting in assembly failure. If the hole is too small the stud may become damaged, break, or break the plate/board it is trying to be installed into. These studs can be made without the undercut on the male threads to help increase the strength of threads and help protect them from sheering off. While we will make some suggestions to help make the project a success, these are only suggestions. Proper engineering and practical testing should be used to make sure that form meets function.

How to order:

When ordering or requesting a quote start with the basic code, add a material type(if hex put an H in front), add the c length, and finally add a finish. For finishes, specifiy if it is going to be commercial or if you have a Mil spec let us know and we will have it done. If there is a modification, be sure to put MOD and whatever the change is to be made. Below are some examples of parts:

You are looking for a 1/2-13 stud out of 7075 Aluminum to fit a 1/8" plate without any finish.
Order part# DEKS19519-ALUM3-.125-PLAIN

You need to get a 1/4-20 x 5/8 stud with a 3/16" out of 12L14 steel with a Clear Zinc finish.
Order part# DEKS19513-STL2-.187-CLZINC

Your application requires a stud with 3/8-16 x 1.250" long threads, in a 1/4" plate, out of hex brass, with a black satin finish.
Order part# DEKS19511-HBRASS-.250-BKSTN-MOD A+B = 1.250
If you have questions about this products uses or possible customizing, please contact us and we will be happy to help come up with a solution for you!